View Full Version : Minolta bizhub 751 lower tray not regognizing paper
kitestir
02-07-2012, 06:41 PM
Has anyone had the bottom universal tray on a 751 not regognize paper and not rise. It just says add paper. I switched trays 3 and 4 to verify it wasnt a tray issue. Going back with firmware, but was wondering if anyone else has had this and could it be the PRCB board?
THanks
ni311
02-07-2012, 07:19 PM
Did you check between the back of the tray and the machine for any paper caught there? The connector on the machine might be blocked.
kitestir
02-07-2012, 07:23 PM
Yes the connector is clear.
ni311
02-07-2012, 07:25 PM
Did you checked the sensors from Service Mode, are they working properly?
TheOwl
02-07-2012, 09:23 PM
Pull the elevator tray and quickly have a look at the harness that sits below the paper lift mech.
Is it damaged at all? Even just the slightest?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.