Guys (Gals) is this a Brother?

[Hansoon]

http://www.ubmltd.co...loads/1600f.pdf

Can't find it in Katun's equivalence list

Hans

[copiman]

Re: Guys (Gals) is this a Brother?

I checked precisionroller.com. They have a cross refrence and it came up with no equivalance. Maybe one of the konica/minolta guys know.

[minimerlin]

Re: Guys (Gals) is this a Brother?

As far as I know it is the follow up to the Di1610! So it will be another piece of crap!!!

[dallas]

Re: Guys (Gals) is this a Brother?

The manufacturer is Sagem.

[minimerlin]

Re: Guys (Gals) is this a Brother?

The manufacturer is Sagem.

Well I hope they built them better this time!!!! Just looked it up on the Sagem website..its the same beast!

[Hansoon]

Re: Guys (Gals) is this a Brother?

Found it:

http://www.tecnotre.it/sogemcom/MF5482n.pdf

I should have known cause a networkscan showed Sagem-Communications as the NIC vendor.

You where right Dallas, thanks (oder soll ich sagen danke!)



Hans

[EarthKmTech]

Re: Guys (Gals) is this a Brother?

It looks like a decent machine, and doesn't have that rubbish standard paper tray that's always an issue.

the di1610/b161 etc wasnt a bad machine when put into the correct environment -

the biggest problems were, the pain in the backside fuser location, rubbish standard paper tray, and also the flaky toner cartridge detection method.

in my experience most of these machines were sold and lived their lives without any callouts, other than 1 final callout which is the "its time to buy a new machine" and put in a sales lead call if it needs a fuser etc. Our time is charged at $250 just to walk in the door so maybe that plays a part in considering a new machine too.