PDA

View Full Version : bizhub c252code c-1183


Custom Search


Bri Ski
03-01-2012, 12:45 AM
Just got this one in. Finisher was tweeked. Any common cause for this particular code? Thanks for any suggestions

scottybbb
03-01-2012, 12:52 AM
See if exit tray is up to far.Exit tray is not in the home position.

JustManuals
03-01-2012, 04:29 AM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)

Paul@justmanuals.com

Darren King
03-01-2012, 07:38 PM
Make sure the bins are making contact with the upper limit sensor actuator on the finisher just under the exit.
Hope this helps.
Darren

Nelo
03-03-2012, 03:54 AM
Just got this one in. Finisher was tweeked. Any common cause for this particular code? Thanks for any suggestions
When outputting paper to Tray 3
PROBABLE CAUSES:
1. The lower adjust plate is not in the correct position.
Note: The FS-519 is configured with an OT-602 (Additional Output Tray) installed in conjunction with an MT-502 (Mailbin Kit) or a SD-505 (Saddle Stitcher Kit).
Position the lower adjust plate in the correct position according to the attached OT-602 Installation Manual.

2. The bracket that holds PS11 is malformed or the sensor may have failed.
Replace the PS11 holding bracket if deemed necessary.

At power up
CAUSE: PS11 has failed.

SOLUTION: Replace PS11

After servicing the finisher.
CAUSE: Improper wire harness routing causing interference with the PS11 elevator home sensor.

SOLUTION: Route the wiring harness through the harness holder correctly.

Worked for me. Region - Oceania

Custom Search