bizhub 350

[etsmultan]

dear! some one has changed default service code(00000000).please help me how can i change it to default or other one!

[blaze2000]

Yikes! Make sure your hitting END that is displayed on the touch screen to get into service mode. Lot of times people don't hit that. If your hitting end and your certain it was changed, you will need to replace the nvram.

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)

Paul@justmanuals.com

[etsmultan]

is there any solution without changing NVram?

[RRodgers]

is there any solution without changing NVram?

Yes, get a new machine.

[Darren King]

I have seen a couple of these machine that do not require a password and simply hitting "end" will log you into service mode.
Hope this helps.
Darren.

[aleksander]

Go to Admin 2 - Memory management - Overwrite all data. Then restart the MFP. Good luck.