PDA

View Full Version : C353 Tray 3 / LCT Problem


Custom Search


doug94550
05-22-2012, 07:33 PM
Hi Guys,
I have a problem with a C353 not recognizing Tray 3 LCT.
The UI shows that the machine see it however when you select your paper trays it only shows Tray 1 and 2.
I am thinking that there is some soft switch I need to throw in order to enable it but I will be darned if I can find where that setting is. I have been going through all of System 1 and 2 along with trying every other field I can think of.
I am relatively new to the product line and still figuring out this box.
Any help greatly appreciated.
Doug

solis557
05-22-2012, 08:09 PM
i believe the tray has malfunctioned and disabled drawer. There is a hole in the back of the machine for tray three near the bottom. I used a screw driver to pop open the drawer to see if paper fell behind the drawer causing the error. i believe if you go into tech rep mode system 1 go to trouble isolation and touch unset next to LCC touch end and the power off the machine using the main power switch for the setting to take effect. hope this helps.

Custom Search