PDA

View Full Version : J1301 on Bizhub 552DS


Custom Search


KMnyafayce
06-11-2012, 11:51 PM
Hey Ya'll,

Got this issue that has just been ripping (literlly) my call backs up. Jamming out of tray three. replaced pickup/feed/sep rollers, conveyance rollers, black feed frame and actuator for a J1301 jam code. It started out as a jam if it was doing three or more pages it would just time out. I did all the recommended updates based on what i could find on Konica Minolta's SSD knowledge base. When I replaced the feed unit black base frame, a different type of jam started occuring. Now what it's doing is kinda rolling the paper between sep roller and metal frame ramp before the sep roller. Not doing it but every 50 sheets or so. Another technician also replaced the motor that provides drive the lower tray's feeding and conveyance.

Could there possibly be anything causing this to occur based on something not put back together right from the motor/assembly being replaced?

Has anyone seen this before?

Thanks.

JustManuals
06-12-2012, 02:05 AM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

KMnyafayce
06-12-2012, 02:44 AM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com



Don't need your services. Since I have access to the knowledge base, I also have access to Konica Minolta's service manuals.

emujo
06-12-2012, 04:45 PM
Slide the paper feed regulating block over about 1/2 inch, grab a piece of emory cloth and get rid of the haze around the shaft..this has fixed a few of these type of jams for me. Emujo

Custom Search