View Full Version : Bizhub 353 Tray 1 feed roller replacement
Venom
06-21-2012, 12:20 AM
Just replaced rollers for tray 1, if anyone knows the engineer who designed this, please kick him in the nuts!
JR2ALTA
06-21-2012, 12:27 AM
Where have you been?
blackcat4866
06-21-2012, 01:11 AM
Yeah, Konica Minolta have to be the most difficult rollers to change in the industry. Canon/HP was the first to use clip on rollers on stub shafts, and most everyone else followed suit most of a decade ago. =^..^=
EarthKmTech
06-21-2012, 10:09 AM
clip on clip off rollers are finally here with the new range of machines.
(still not as easy as you still have the white plastic clips and the crappy 1 way bearings are still there)
PS, im changing tray 1 rollers in a c203 on Monday, its a good excuse to plant Ur ass on the ground and chill-ax with a screwdriver removing the bypass tray etc.
If your not chillaxed, your in the wrong profession ;)
minimerlin
06-21-2012, 08:55 PM
You forget that the Minolta Di30 had very easy to change rollers, swing out the left hand side and there they were..slide on/off, even a user could do it! Then it was all down hill ...:rolleyes:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.