PDA

View Full Version : CQ Bizhub c252 cutting off


Custom Search


deliver
06-27-2012, 06:48 AM
Hello, My c252 is shifting in the scan direction. Its fine when running prints or internal prints, it's only when you run anything through the ADF or on the glass. I noticed that the scanner was positioned about an inch past the document stop. I had suspected the image processor( the board that's under the lens) I brought the scan motor and home position sensor as well and installed. the scanner went back to it's normal position but when I ran a copy the same thing occurred. It scanning the proper length but starts scanning late so it goes past the page and scans the sky. Any suggestions? thanks

JustManuals
06-27-2012, 06:55 AM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

Custom Search