View Full Version : Electrical Konica Minolta DI3510
CCS@yahoo
06-27-2012, 06:49 PM
customer has DI3510, stays in warm up screen ( illustrations of 4 or 5 copiers ). attempted reboot, trouble reset; occasionally system goes to ready and becomes operational - 10% operational, 90% inoperational. Eventualy goes back to 'initial start up' screen and freezes up. Used as their printer - possible computer system issue ? Could use some help with this one
solis557
07-12-2012, 06:14 PM
I would remove the network cable from the device and see if the machine goes to the ready state. I had one where the nic went bad and would make the machine reboot, but once i disconnected the network cable it would copy fine.
BR549
07-14-2012, 07:25 PM
Try disconnecting HDD. I had the same problem and that is what it was.
JustManuals
07-15-2012, 06:10 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)
Paul@justmanuals.com
RRodgers
07-15-2012, 07:13 PM
Check power as well, also might need a flash.
try remove the NC4 scan unit card and see. if still error rewrite firmware .:cool:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.