PDA

View Full Version : Error Code Konica Minolta C20 Error Code 13F0


Custom Search


atiq
07-02-2012, 10:40 AM
One of our clients machine has come up with the following code:

“Machine Trouble Service Call (13F0)”

I have a rough idea it could be one of the dev units.

Regards
Atiq

Gaffers01
07-02-2012, 01:14 PM
One of our clients machine has come up with the following code:

“Machine Trouble Service Call (13F0)”

I have a rough idea it could be one of the dev units.

Regards
Atiq


That error code is likely something more serious to do with the main boards if I remember rightly,
check no cables have come loose.

Hansoon
07-02-2012, 07:43 PM
From the book:

13F0: Engine control failure

Relevant electrical parts
Print control board (PRCB) MFP board/1 (MFPB/1)
1-Check the cable and connector for proper connection and correct as necessary.
2 Change PRCB.
3 Change MFPB/1.

Hans

JustManuals
07-02-2012, 07:50 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

remati
07-02-2012, 09:32 PM
Normaly is a "flat cable" that connect the boards "PRCB andMFP"... is a small one

...but check all the connections and all the flat cables on the boards

Best regards




One of our clients machine has come up with the following code:

“Machine Trouble Service Call (13F0)”

I have a rough idea it could be one of the dev units.

Regards
Atiq

MFPTech
08-07-2014, 09:27 PM
Normaly is a "flat cable" that connect the boards "PRCB andMFP"... is a small one

...but check all the connections and all the flat cables on the boards

Best regards

Has this been resolved please?
Toda i had a brand new machine out of the box with this error. The machine initializes the scanner and fuser, stays in warming up phase for a while and instead of going to Ready it throws the error. The fuser is hot.
The service manual says it's an engine error and recommends rebooting the main unit. Tried to write firmware but the moment I turn the machine to bootrom mode the error led is on.
Thanks in advance!

Custom Search