PDA

View Full Version : CQ konica c6500


Custom Search


beano
08-30-2012, 01:06 AM
i did a pm today replaced 4 drums , dv's y,m,c,k , 4 charge units transfer belt and transfer rollers ran the adjustments i have whit dots and streaks on all copies went over transfer belt and rollers 3 times everything were put on right :mad:

1FRY1
08-30-2012, 10:50 PM
Samples would be good ?

JustManuals
08-30-2012, 11:38 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

beano
08-31-2012, 01:52 AM
1705417053

inutelkamo
09-13-2012, 05:54 AM
Hey there..

Have you try to clean the PH? or the Mylar tapes below each of dev unit where laser beam passes?

If done, check your transferbelt, the guide side rubber behind it were probably worn, and in some cases, these rubber scatters and stick with the three rollers, this might cause problem in image transfer..

Thnx..

Hope can help.

1FRY1
09-13-2012, 08:22 PM
is the image like that on the transfer belt ?

have you checked the black mylar by the transfer roller on the ADU they get damaged just rip it off

It definatly looks like scraping of the image

Main thing though is it like that on the belt

Albonline
09-13-2012, 08:51 PM
There is a batch of bad developer out there, suspect it got overheated in transit.

Custom Search