C252 yellow background

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • brianho80
    Trusted Tech
    100+ Posts
    • Sep 2009
    • 198

    C252 yellow background

    Hi Guys,

    does anyone know what happen to this attachment sample printed from C252?

    Action that i have taken as below:

    run color registration; run gradation adjustment; upgrade firmware and change of yellow IU unit (used and good condition) but background remain there.

    somehow, it appear P-21 and P7 but disappear after reboot and reset it.

    anyone has ideas what to do next?

    background.jpg
  • Dickie
    Trusted Tech
    100+ Posts
    • Nov 2011
    • 187

    #2
    Re: C252 yellow background

    Had the same type of issue but with green background a couple of years ago on a 35 page a minute machine.
    The solution was to clean around all the imaging unit electrical contact pick up points on the rear frame.
    Use a brush and clean lint free cloth, do not try using an air duster as the waste toner take away ducts are close to these points which is usually the cause of the contamination.
    Hope this helps

    Comment

    • JustManuals
      Field Supervisor
      5,000+ Posts
      • Jan 2006
      • 9932

      #3
      Re: C252 yellow background

      This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


      Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


      Paul@justmanuals.com

      Comment

      • paulrid
        Trusted Tech
        100+ Posts
        • Nov 2011
        • 206

        #4
        Re: C252 yellow background

        Check out mt thread here http://www.copytechnet.com/forums/ko...-problems.html For me it was the MFP but theres some good thing to check in there.
        paul.

        Comment

        • kimoncopiers
          Technician
          • Feb 2011
          • 12

          #5
          Re: C252 yellow background

          I had the same problem last year and i solved it.

          First of all go to the service mode :
          1. go to stabilizer
          2. push the stabilizer reset/backround & start
          3. if this finish, push stabilizer only.
          4. go to the gratation and doing the three automatic gratation.

          I believe with this, you can solve your problem.

          If you do not understund something ask me again. kimoncopiers@yahoo.gr

          Comment

          • Chip Resets SA
            Technician
            • Sep 2010
            • 46

            #6
            Re: C252 yellow background

            Go into service mode reset and initialize machine redo set up if no joy replace control board.

            Comment

            Working...