methogod
10-30-2012, 11:51 PM
machine will print if i print to the internal print controller, fiery has seemed to fail to rip any new documents in over a month. i use it to scan mostly and that now doesn't seem to be working either.
software is 1.01, and was all current. Tried rebooting, clearing and a few complete power downs.
My tech says it could be hard drive or system software. Would like to narrow it down a bit more. In tech mode nothing is for the fiery just for the Emperion controller.
When i print to the fiery, it comes up as UNKNOWN every time.
if i print to the internal controller it print just fine.
i have a C550 parts machine that has a fiery, as well a C650 that is still in production. So i can swap with that if need be to test wires and cables.
thanks,
software is 1.01, and was all current. Tried rebooting, clearing and a few complete power downs.
My tech says it could be hard drive or system software. Would like to narrow it down a bit more. In tech mode nothing is for the fiery just for the Emperion controller.
When i print to the fiery, it comes up as UNKNOWN every time.
if i print to the internal controller it print just fine.
i have a C550 parts machine that has a fiery, as well a C650 that is still in production. So i can swap with that if need be to test wires and cables.
thanks,