bushy
11-01-2012, 09:51 AM
I have a problem with this Konica c451 with the copies ok from the glass but very pale and yellow through the adf
Prints are good only copies that pass through adf lose copy quality
Have tried adjusting density and swtiching to photo mode with limited success but then the copies from the glass go too dark and crappy
Was wondering what is the difference in the two systems
Previous techs have swapped the ccd with no joy
There must be a system difference between adf scans and flat bed scans
Was wondering if swapping the adf would cure my problem or am I on the wrong track
I remember tha there was an adjustment on the old Konicas through the adf where you had to pass a white sheet through the feeder in a tech mode which calibrated the a/e on the adf scanned copies but I dont know any adjustments on these m/s
Any help appreciated
Bushy :confused:
Prints are good only copies that pass through adf lose copy quality
Have tried adjusting density and swtiching to photo mode with limited success but then the copies from the glass go too dark and crappy
Was wondering what is the difference in the two systems
Previous techs have swapped the ccd with no joy
There must be a system difference between adf scans and flat bed scans
Was wondering if swapping the adf would cure my problem or am I on the wrong track
I remember tha there was an adjustment on the old Konicas through the adf where you had to pass a white sheet through the feeder in a tech mode which calibrated the a/e on the adf scanned copies but I dont know any adjustments on these m/s
Any help appreciated
Bushy :confused: