PDA

View Full Version : cl7200 fuser message


Custom Search


zspyder
01-10-2008, 06:58 PM
Hi fellow techs, I replaced a fuser in a cl7200 because it said it was time to replace type c fuser, how do I clear the message ?:confused:

Cipher
01-10-2008, 09:30 PM
New fusing units have a spring that makes a circult.

When the rollers turn for the first time the spring disconnects breaking the circult which tells the machine it a new unit and it resets the PM counter automatically.

Alternatively you can manually reset the fuser PM counter using SP7804-016.
Or you can take plastic top off the fuser and reconnect the spring clip next to the gears.

zspyder
01-11-2008, 01:20 PM
thanks for the reply, however I don't know how to get into the mode to reset the fuser count. I have to service this machine with NO manuals at this time for a customer so any help is GRAITLY apprecheiated.

Cipher
01-11-2008, 02:15 PM
Reset the spring on the fuser, it does the same thing.

zspyder
01-14-2008, 09:13 PM
Thanks DaZ, however that did not work. the original fuser did not have a spring at the end. the new fuser does but it is still atattched. I don't know how to enter service mode to manually reset the count. Any ideas.

Cipher
01-15-2008, 10:39 AM
Yup look it up in the service manual.

Scott_Lewis
01-19-2008, 05:28 AM
Thanks DaZ, however that did not work. the original fuser did not have a spring at the end. the new fuser does but it is still atattched. I don't know how to enter service mode to manually reset the count. Any ideas.

Checkout section 5.1.1 and SP5803 of the service manual.

Custom Search