cl7200 fuser message

[zspyder]

Hi fellow techs, I replaced a fuser in a cl7200 because it said it was time to replace type c fuser, how do I clear the message ?:confused:

[Cipher]

New fusing units have a spring that makes a circult.

When the rollers turn for the first time the spring disconnects breaking the circult which tells the machine it a new unit and it resets the PM counter automatically.

Alternatively you can manually reset the fuser PM counter using SP7804-016.
Or you can take plastic top off the fuser and reconnect the spring clip next to the gears.

[zspyder]

thanks for the reply, however I don't know how to get into the mode to reset the fuser count. I have to service this machine with NO manuals at this time for a customer so any help is GRAITLY apprecheiated.

[Cipher]

Reset the spring on the fuser, it does the same thing.

[zspyder]

Thanks DaZ, however that did not work. the original fuser did not have a spring at the end. the new fuser does but it is still atattched. I don't know how to enter service mode to manually reset the count. Any ideas.

[Cipher]

Yup look it up in the service manual.

[Scott_Lewis]

Thanks DaZ, however that did not work. the original fuser did not have a spring at the end. the new fuser does but it is still atattched. I don't know how to enter service mode to manually reset the count. Any ideas.

Checkout section 5.1.1 and SP5803 of the service manual.