doug94550
12-27-2012, 06:59 PM
Hi Guys,
This is a follow up to my previous post on this problem.
Once again, I have a 751 with a C-6708.
When the machine initializes, the scanner runs to home and then moves out to the white reference.
When the lamp illuminates, it actually flashes on and off about 6 times.
If I reach back and push down the plunger as if the ADF were closed, the lamp illuminates and stays illuminated, no flashing.
This is the cause of the C-6708.
I have replaced the Inverter and the driver board.
The problem began after the Print Driver chip was installed. For what I can see, the Print Driver chip is essentially a jumper to enable the Print Function.
I was able to get the Firmware and was ready to Flash the machine but in order to do this I have to go through the Service Mode, System 2, ISW.
And here is where I hit the wall.
I can enter Service Mode just fine. When I get there, in the upper right corner, it shows the C-6708 code.
From that point, when I try to select anything, the machine just throws up a "Please Wait" next to the code and it just sits there.
I can reset the code, however, when I do, the machine initializes again, the lamp flashes, and the code returns.
Is the a backdoor way to bypass this code and Flash the machine?
Any and all ideas gratefully appreciated.
Have a Happy New Year Everybody!!!
Doug
Oh Yeah, one more thing. Does anyone have the part number for the system board?
This is a follow up to my previous post on this problem.
Once again, I have a 751 with a C-6708.
When the machine initializes, the scanner runs to home and then moves out to the white reference.
When the lamp illuminates, it actually flashes on and off about 6 times.
If I reach back and push down the plunger as if the ADF were closed, the lamp illuminates and stays illuminated, no flashing.
This is the cause of the C-6708.
I have replaced the Inverter and the driver board.
The problem began after the Print Driver chip was installed. For what I can see, the Print Driver chip is essentially a jumper to enable the Print Function.
I was able to get the Firmware and was ready to Flash the machine but in order to do this I have to go through the Service Mode, System 2, ISW.
And here is where I hit the wall.
I can enter Service Mode just fine. When I get there, in the upper right corner, it shows the C-6708 code.
From that point, when I try to select anything, the machine just throws up a "Please Wait" next to the code and it just sits there.
I can reset the code, however, when I do, the machine initializes again, the lamp flashes, and the code returns.
Is the a backdoor way to bypass this code and Flash the machine?
Any and all ideas gratefully appreciated.
Have a Happy New Year Everybody!!!
Doug
Oh Yeah, one more thing. Does anyone have the part number for the system board?