PDA

View Full Version : Konica c652 installed PI-505 Post Inserter


Custom Search


Oscar57
01-09-2013, 08:24 PM
Hi,


Just installed a PI-505 Post Inserter on a Konica C652. It works fine printing through the Fiery. But when I try to use it offline for some folding the on/off button is lit amber instead of green. Is there a setting in service mode or a software switch setting that must be changed. I'm stuck so any input would be much appreciated.

Flash
01-09-2013, 10:03 PM
Try doing the paper size adjustment and make sure the paper is in the same orientation as the main body paper supply.

Oscar57
01-10-2013, 12:16 AM
Try doing the paper size adjustment and make sure the paper is in the same orientation as the main body paper supply.

Yes, I tryed that already. It seems almost like it should be in a different mode for offline operation. I'm hoping its a software setting?

Itsthepaper
01-10-2013, 02:49 AM
Considering you followed the paper size detection adjustment after install properly then check out bulletin TAUS0902717EN00. Firmware updates to improve the capabilites of the PI-505.

blackcat4866
01-10-2013, 02:56 AM
Yes, I screwed up the size adjustment the first time around. Be sure to read the procedure all the way through. It won't function at all until the size is adjusted correctly. =^..^=

Custom Search