PDA

View Full Version : Bizhub 362 whit abort code


Custom Search


DadO
01-28-2013, 02:22 PM
For the record, I had same problem 9 months ago but fix it whit reinstalling memory boards, faxkit and firmware.Now its back again :mad:
Abort code
19123

I tried reinstalling fax and memory but didnt help. When i disconnect print cable, machine works fine but when i connect print cable (tcp/ip type of connection), exclamation mark ( !) shows near memory status and memory drops on 99%
19127
Then 1 minute later i get abort code!.

I didnt instal memory in this machine , it was done by someone else (not from my company) so i took picture to show u guys what u think is this correct OEM konicaminolta memory. Machine says it have via configuration print page 320mb of memory and in service mode on machine configuration says it have 128 mb instaled memory.

19128

Fellow techs give me some well needed guidance! THANK YOU!

mo0651
01-28-2013, 03:46 PM
Check the computers printing to the machine. Someone sent a bad print job and is causing this. Google maps does this to Bizhub 200 series.

dallas
01-28-2013, 05:55 PM
- a TCP/IP Address conflict
- disable SLP in Network Tab via Webconnection

Darren King
01-29-2013, 12:58 AM
This abort code is almost always a problem with a print job. Clear the print queue on all computers printing to this machine, power cycle the copier and all should be good until the next time.
Darren

JustManuals
01-29-2013, 07:52 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)



Paul@justmanuals.com

Brischaffer
01-29-2013, 08:20 PM
Had the same issue on one. It is definitly a bad job on someones computer.

Custom Search