DadO
01-28-2013, 02:22 PM
For the record, I had same problem 9 months ago but fix it whit reinstalling memory boards, faxkit and firmware.Now its back again :mad:
Abort code
19123
I tried reinstalling fax and memory but didnt help. When i disconnect print cable, machine works fine but when i connect print cable (tcp/ip type of connection), exclamation mark ( !) shows near memory status and memory drops on 99%
19127
Then 1 minute later i get abort code!.
I didnt instal memory in this machine , it was done by someone else (not from my company) so i took picture to show u guys what u think is this correct OEM konicaminolta memory. Machine says it have via configuration print page 320mb of memory and in service mode on machine configuration says it have 128 mb instaled memory.
19128
Fellow techs give me some well needed guidance! THANK YOU!
Abort code
19123
I tried reinstalling fax and memory but didnt help. When i disconnect print cable, machine works fine but when i connect print cable (tcp/ip type of connection), exclamation mark ( !) shows near memory status and memory drops on 99%
19127
Then 1 minute later i get abort code!.
I didnt instal memory in this machine , it was done by someone else (not from my company) so i took picture to show u guys what u think is this correct OEM konicaminolta memory. Machine says it have via configuration print page 320mb of memory and in service mode on machine configuration says it have 128 mb instaled memory.
19128
Fellow techs give me some well needed guidance! THANK YOU!