PDA

View Full Version : Error Code Konica 7222 F51-2


Custom Search


Laserbeam
03-02-2013, 11:20 PM
Hi at all,

after switched on Konica 7222, following error code appears after a short time: F51-2 (during the warm-up phase, the exit and fixing roller doesn't rotate). I replaced the fixing unit (I suspected a sluggishness), but the same problem occurs. In the 47 programm (output signal), code 40, the exit and the fixing roller are rotating properly (M11 - Fixing motor is ok!).

any ideas?

JustManuals
03-03-2013, 12:41 AM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

fixthecopier
03-03-2013, 01:18 PM
Sounds like it is time to look at the sensor that detects the rotation.

Laserbeam
03-04-2013, 09:01 AM
where is these sensor?

fixthecopier
03-04-2013, 10:08 AM
where is these sensor?




you should buy a manual and you will know!

Custom Search