View Full Version : konica bizhub 200 crooked copy
hi i have a bizhub 200 that is producing crooked copies. i have cleaned all rubber. happens from all trays, from platen and doc. any ideas thanks
JustManuals
03-04-2013, 04:54 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)
Paul@justmanuals.com
Hansoon
03-04-2013, 06:45 PM
If it happens with internal print outs and if "crooked" means warped than have a look at the sync roller bushings. They could be worn.
ADF or even scanner can also cause similar effects but with your rudimentary description its guessing from my side of course.
Hans
Darren King
03-05-2013, 05:45 PM
If prints are straight but copies are skewed, grab the left front corner of the scanner bed and lift up sharply. That will straighten out the scanner bed.
Hope this helps
Darren
fixthecopier
03-06-2013, 12:08 AM
I have had crap get under the reg roller and cause problems. I had one that had a piece of packing material rolling around under it for 4 years before it jammed itself in the roller.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.