PDA

View Full Version : konica 7022 2 sided doc feed problems


Custom Search


DOE
03-25-2013, 07:39 PM
hi i have a konica 7022 that has some problems when doing 2 to 2. the document feeder will sometimes ( 1 OUT OF 20 DID IT FOR ME) make like a groaning or slipping noise and then jams. the other 19 times it worked fine. customer says it usually happens more frequently. single side works fine all the time. i have replaced the clutches in back but same problem. all rubber has been cleaned. any ideas

JustManuals
03-25-2013, 08:31 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

pepper38_cnd
03-25-2013, 09:36 PM
One of the 2 solenoids on the front of the adf is sticking it's usually the one on the right. You can just hold it in and See if you get the same results I'm sure you will recognize the sound.

DOE
04-10-2013, 12:16 AM
hi i replaced both sylenoids and still have same problem. only on 2 to 2 you sometimes get a humming noise when you push print button and you know its going to jam. thought for sure sylonoids would take care of it but no luck. any other ideas?

SmellsHot
04-10-2013, 01:11 PM
i believe theres a one way gear near the reverse motor. Try cleaning and scrubbing the shaft.

CraigW
04-10-2013, 07:44 PM
Have you looked at the underneath ? There is a conveyance roller and the holder splits at rear and will give 2-2 jamming. Have to look kinda close to spot it. #13GL45070 Conveyance Guide Part/Upper Seen these broken often.

DOE
04-17-2013, 05:00 PM
i have replaced and tried everything suggested with no luck. just easier to replace doc. feeder

Custom Search