PDA

View Full Version : Bizhub C360


Custom Search


Nelo
03-27-2013, 01:12 AM
Got a bizhub C360, no finisher attached but displaying messages 1) Z - fold cannot be used currently, 2) Hole punch cannot be used currently, 3) Only black and white printing is now possible. Need assist in having this warning messages removed from display panel.

Thanks

blackcat4866
03-27-2013, 01:18 AM
Two places to check:
1) in Utility/Counter > check the Consumable List to see if the color developer units are due for replacement
2) in service mode check System 2 > option board installation > set or unset (it sounds like someone enabled a bunch of options that are not installed).

=^..^=

JustManuals
03-27-2013, 03:02 AM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

Nelo
03-27-2013, 08:00 AM
Two places to check:
1) in Utility/Counter > check the Consumable List to see if the color developer units are due for replacement
2) in service mode check System 2 > option board installation > set or unset (it sounds like someone enabled a bunch of options that are not installed).

=^..^=

Thanks, changed all deve units and the "print black and white only is possible" is gone. In the service mode Syst 2 does not have option boards for finisher. Even no related funtions to set in Sys 1, problem unit isolation section as in the c224's.

EarthKmTech
03-27-2013, 03:30 PM
Goto the trouble isolation menu in service mode and correct the settings as required.

If it's not this, it may have a failed PRCB or corrupt NVRAM,

I would hope the machine is running the latest firmware.

Custom Search