PDA

View Full Version : Replacing entire Konica C500 ADU drawer


Custom Search


henry finley
04-01-2013, 09:08 PM
I have a Konica C500 where the whole ADU drawer--the whole thing is the biggest irritant ever in my life. It won't feed, it jams, it prints crooked. In a 250 sheet run I bet I have to pull that damn drawer out 200,000 times. I have a junk C500 where the unit worked fine. Can I just trade the whole drawer assembly--the entire kit and kaboodle? Or will there be a software conflict? Thank you.

knightfall
04-02-2013, 02:52 AM
as far as I remember of the beast the adu is just a unit no software just hardware, so swopping it should have no software conflicts. while you have the adu out check the connectors for cracks or paper inside.

henry finley
04-02-2013, 06:03 AM
as far as I remember of the beast the adu is just a unit no software just hardware, so swopping it should have no software conflicts. while you have the adu out check the connectors for cracks or paper inside.

Thank you, friend. Perhaps you have made my excruciating annoyances easier with this knowledge.

Custom Search