View Full Version : 6000L error code
Im off to a 6000L tomorrow with a C3102 error code. I only have the one out and from memory I think its to do with a one way bearing in the fsr, but seeing as Infohub is all f****d up im losing the will to live trying to find info on it.
Can anyone remember which gear/one way bearing caused this error or am I on the wrong path.
Cheers
tech51
04-08-2013, 08:07 PM
If I remember rightly it can be the three one way gears in the drive unit or the torque limiter that sits under the lower roller.
JustManuals
04-08-2013, 08:13 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)
Paul@justmanuals.com
tech51
04-08-2013, 08:39 PM
20268
Im off to a 6000L tomorrow with a C3102 error code. I only have the one out and from memory I think its to do with a one way bearing in the fsr, but seeing as Infohub is all f****d up im losing the will to live trying to find info on it.
Can anyone remember which gear/one way bearing caused this error or am I on the wrong path.
Cheers
Battled the infohub and found this!!!!!
humpty dumpty
04-08-2013, 08:54 PM
C-3102 error code.
Solution
CAUSE: The Fusing drive gear /M (22T) uses a one-way clutch. After a period of time, this one-way clutch may slip and is unable to drive the gear.
SOLUTION: Replace the gear (p/n A03U 8093 11).
hope this helps
matt
C-3102 error code.
Solution
CAUSE: The Fusing drive gear /M (22T) uses a one-way clutch. After a period of time, this one-way clutch may slip and is unable to drive the gear.
SOLUTION: Replace the gear (p/n A03U 8093 11).
hope this helps
matt
I think thats the baby. Cheers
20268
Battled the infohub and found this!!!!!
Thanks. Can't even get on to Infohub now. Just getting the spinning wheel of death...
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)
Paul@justmanuals.com
Thanks already got it Paul.
If I remember rightly it can be the three one way gears in the drive unit or the torque limiter that sits under the lower roller.
Yes thats what Im thinking . Thanks
* UPDATE *
Man it pisses me off when people don't update thier posts with the fix, and then i go and do it :p
In the end it turned out to be the Conveyance board or thr ADU board as it used to be called.
Thanks to everyone that posted ideas.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.