View Full Version : J18 DP 8060
ESTANISLAOWENENTON
04-27-2013, 12:10 AM
HELLO
IN A MACHINE DP 8060, ERROR APPEARS J 18
CASETT LEAF LEAVES 3 O 4 WELL
BUT J18
HE TRIED IN F4 SENSORS AND WORK WELL
IF I LEAVE THE PAPER, SHUT OFF and turn on, SHOW JAM
SEEMS TO BE WELL SENSOR
THANKS FOR YOUR HELP
YOU HAVE THE MANUAL JUSTMANUAL
onetek
04-29-2013, 02:54 PM
I have had severall j18 jams comming from the first paper feed clutch ( the one closest to pickup rollers). You can isolate your problem by switching paper feed units from one drawer to the next.)
ESTANISLAOWENENTON
04-30-2013, 09:52 PM
THANKS FOR ANSWER
NOW THAT I DID,
still jams
THANKS
JustManuals
04-30-2013, 10:32 PM
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)
Paul@justmanuals.com
copiman
05-01-2013, 02:01 PM
Does it jam out of all 4 trays?
ESTANISLAOWENENTON
05-02-2013, 02:05 PM
Does it jam out of all 4 trays?
thanks for answering
j 08 now
not only clogs the 3 and 4
swap the 1 and 2 for the 3 and 4
jams
paper goes well the cassett be 3 or 4, but is at the top right
ok the sensor half sen
timing
ok the timing sensor
tahnks
onetek
05-02-2013, 02:31 PM
Is it giving j18 jams or j08 jams? J08 jams could point to intermediate transport rollers or clutch.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.