PDA

View Full Version : Konica Minolta C552 error C-3724


Custom Search


Alex1
05-23-2013, 04:31 AM
Hi,

hi have a Konica Minolta Bizhub C552 giving a error C-3724. Any suggestions?

emujo
05-23-2013, 08:00 PM
Fuser high temp...you can, carefully, try and reset the code using the trouble reset. I would not do this twice in a row with the fuser warmed up or you may start melting things. If the fuser is near or past life span replace it. Emujo

JustManuals
05-23-2013, 10:19 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

tech51
05-23-2013, 10:50 PM
We had one do this recently and it was a faulty temperature sensor which sits on the black plate below the fuser. There are two sensors on the plate and we proved it was the sensor by swapping the sensors over. The fault code then changed. It's worth doing this as we mistakenly replaced the fuser before doing this test. Hope this helps.....

B0265
09-10-2013, 09:39 AM
Hi,

hi have a Konica Minolta Bizhub C552 giving a error C-3724. Any suggestions?

Did you find the solution?
We have a C652 with this code. So far we have replaced the fusing unit, IH Power supply, PRCB and the heating roller temp sensors (as tech51 sugessted).

Custom Search