LED cleaning tool for c351

[realmudd]

This may be a strange question but I am trying to figure out how to use the LED cleaning tool. I know there is an adhesive pad that needs to be changed, and I have those pads, but from there I am lost. I've looked online, forums, service manuals, etc and nowhere says anything about the use or "how to" on this. I need very specific instruction because I don't even know where to "stick" it in. Any help on this will be greatly appreciated.

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

[blaze2000]

The cleaner should be on the inside of the door it's made of a metal shaft with a small handle (I think blue) on one end and the other has a small plastic block where you attach the cleaning pads. When you remove each PCU you have access to the print head. Simply run the cleaner back and forth over the LPH to remove contaminants.