PDA

View Full Version : Konica C652 / Olivetti MF651 Fuser Code C3925


Custom Search


pajeroid
08-22-2013, 08:58 AM
Tried everything excluding the IH coil and IH coil board (at the front under the control panel).

We haven't got a donor machine as the boards are different on the C452 etc - Has anyone had this before? Don't want to order the wrong thing really.

Tried...

Fuser, Power Board, Relay Board (Behing Power Board), Fuser Temp Sensors (3 under fuser), ICP17 on PRCB.

Many thanks in advance,

Dave.

rrrohan
08-22-2013, 11:54 AM
check the Fuse on the IH Coil Board

JustManuals
08-22-2013, 07:51 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)



Paul@justmanuals.com

pajeroid
08-23-2013, 09:24 AM
check the Fuse on the IH Coil Board

Just tried a whole new IH board with no difference... only the coil left - I've removed it and checked the three coils, but they all show continuity and a resistance of 0.9 M Ohm, does this sound about correct?

Think this may be a printer control board issue.

Dave.

habik
08-28-2013, 08:26 AM
Hi Dave,

Have you tried reloading the firmware and what about fuser new release reset after fw update?

Good luck

Bedo
03-30-2016, 01:14 PM
Hi, I have exactly this problem on a Konica Bizhub C652
I've tried to susbsitute Fusing Unit, IH Coil Unit, 3 Sensor OF Tems, PRCB, Relay drive Board and micro of open/close the right door.
I've alredy update firmware, but the machine dosen't start.
The error is C3925
Could help me to resolv this problem?
Thanks.

PS: Sorry for my english:cool:

pajeroid
03-30-2016, 05:34 PM
Probably a silly question, but have you done the fuser reset procedure?

Power on whilst holding down Utility/Counter until dot in top right corner.

Wait.

Press 'Trouble Reset'.

Machine shows 'OK'.

Power off and on again...

Good luck!

Custom Search