AB1984
10-03-2013, 09:09 AM
I just took out the cleaning blade to give it a bit of a clean because I noticed a few streaks on our prints. After returning everything we are now getting loads of streaks (in the direction of print) I pulled it out again to see if I could rectify, or spot a problem, nothing out of the ordinary, so returned it and the streaks remain in the same place.
A bit troublesome, we have prints with a fair amount of solid black on them, and only one of our three 1200s can actually manage it, even if the rollers are knackered in the fuser :-s.
Any help to get it back to (solid) black, greatly appreciated.
Cheers
A bit troublesome, we have prints with a fair amount of solid black on them, and only one of our three 1200s can actually manage it, even if the rollers are knackered in the fuser :-s.
Any help to get it back to (solid) black, greatly appreciated.
Cheers