PDA

View Full Version : Bizhub C352 error S-1


Custom Search


eugenionitza
10-10-2013, 09:06 PM
Hi!

1. Recently my Bizhub C352 shows an error code 'S-1'. In the manual it says 'It is detected that the CCD clamp gain adjustment value is faulty'.
I tried re-plugging the clamps, but the error persists.


2. Also, when copying a large rectangle appears in the center of the paper, covering the image. (see attached photo)

Please, give me an advice or a hit that might help me with these issues.

Thank you,
Eugen

Mr Spock
10-10-2013, 11:36 PM
lamp,mirrors,ccd,slg,memory, or mfp pwb.

eugenionitza
10-12-2013, 01:54 PM
I unplugged the clams, I verified the clams and tapes, I re-plugged them and now it displays this error code 'C-9401'.
The lamp neither moves or lights up.
Do you think when unplugging I somehow damaged the tape connected to it or should I check something else?

Thx,
Eugene

eugenionitza
10-14-2013, 05:00 PM
plss help

thanks

Albonline
10-14-2013, 05:19 PM
replug in the ribbon cable , clean the optics and lasers, run initial setup if this doesn't fix it call in a certified tech.

a4o7910
10-14-2013, 06:06 PM
Clean optics

eugenionitza
10-14-2013, 08:33 PM
thanks.... I found out that the ribbon was defective.
Can anyone help me with a spare ribbon cable ?
I will pay for it.

Thanks

Eugene

Custom Search