Misspass C452

[Imsdal]

Can someone help me with this problem. Is a bizhub C452.
Misspass on the rear part of the print and it doenst matter if it is 1 sided or 2 sided same issue.
I have Clean all the sensors under the belt, clean the optic and the lasers i have also change the transferbelt, transfer roller, and do the stabilization and calibration(Gradiation adjust) in service mode 6 times. And even the skew adjust.
But no luck. The examples are A3.

[mo0651]

Re: Misspass C452

If you remove the fuser unit, clean the the loop sensor located on the frame below it. It may be dirty or stuck.

[Imsdal]

Re: Misspass C452

Thanks for the advice, but I have already done that. I cleaned up all the sensorns and arms.

[emujo]

Re: Misspass C452

replace the laser unit, follow the steps in the SM for inputting the skew adjustment #s. Emujo

[JustManuals]

Re: Misspass C452

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[Imsdal]

Re: Misspass C452

I have change the PH-Unit and done the skew adjustment. I have also change the registration unit below the transferbelt and no use. What is next.

[dallas]

Re: Misspass C452

For me, it looks like a problem with the Fusing speed. Play a little bit in Service Mode.
Resolve the speed playing the shift, use this short time and order a new loop Actuator and a new Fusing Unit.

[Imsdal]