View Full Version : Bizhub 420 firmware change failure
copycommerce
10-17-2013, 12:57 PM
Hello ,
After unsuccesfull firmware change one of our Bizhub 420 stuck's on lit display only.Is there a way to reset the firmware to factory?
Shadow
10-17-2013, 01:25 PM
try downloading and installing the oldest level of firmware on the KM site.
check for any special firmware as well.
copycommerce
10-17-2013, 02:24 PM
Alrdy tryed that but the display is still only lit with power LED on ...
It worked after removing both batteries on the MFP board..
thx
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.