Pls. help on Bizhub 350 output copy is a little oblique/slanted...how to fix?

[Bizhub350]

Guys please need help on how to fix Bizhub 350 output copy is a little oblique or slanted...thank you
22591

[fixthecopier]

You take the cover off the front side of elevator, or output tray, and you pull off the gear and belt and put in correct position and reassemble.

[JustManuals]

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads (http://www.justmanuals.com)


Paul@justmanuals.com

[blackcat4866]

So ... is it an optical skew from a print, an optical skew from a copy, or a paper skew? =^..^=

[Don N.]

THIS IS YOUR FIX...
Remove glass and use a hex wrench (maybe 1.5mm? or 1.27?) on front and/or rear black hex screws that have threadlock on them in the CCD/lens box. Twist 1/4 turn cw or ccw and note the change. test, correct as needed. If you go too far, you will see black ribs on edges. Anytime these are rolled around and strongly vibrated, we notice optic skew, even when adjusted correctly, then delivered to customer a bounce on the sidewalk or worse yet, concrete with cobblestone is sure to do it, so be careful when moving! This is a standard part of our refurb process.

[Bizhub350]

it is a skew from a print out but my original is perfectly fine...and I notice if I do a tests pattern copy the turn out is fine and not skew...only when i copy a fine one the output is skew... thanks for all your help guys

[Hansoon]

Yank up the left front corner of the scanner unit. Somebody was leaning on it and it went down a little.

This is the most common cause of skewing in the copy mode by all machines of this design starting with the Di-350 through Di-351, Di-3510 series until the BH-350's and likely also the BH-362 series.

Hans

[Bizhub350]

Hansoon tnx it really works Yanking up the left front corner of the scanner unit, now the output copy is A okey no more skew tnx again...your the man...

[Hansoon]

Glad you solved it and thanks for the feed back.

Hans