wseyller
10-29-2013, 11:36 PM
Trying to use the post inserter for finishing preprinted 11x17 fold/staple
Installed on a bizhub 652. Total counter is only 100k. I don't think they have ever tried to use the post inserter until now.
Added sheets of 11x17 to the bottom feed tray. select the finishing option. the start/stop button is lit up orange and doesn't do any thing.
I will say that I have no experience with the post inserter. I have read through the Theory of Operation in the service manual but still don't have a clue.
There is a sensor on the tray below the pickup roller. Not sure if it is a set sensor but it does work in sensor check. After looking at the manual it appears that the tray should lift but this doesn't happen. Doesn't seem the manual explains what exactly tells the lift motor to start.
Installed on a bizhub 652. Total counter is only 100k. I don't think they have ever tried to use the post inserter until now.
Added sheets of 11x17 to the bottom feed tray. select the finishing option. the start/stop button is lit up orange and doesn't do any thing.
I will say that I have no experience with the post inserter. I have read through the Theory of Operation in the service manual but still don't have a clue.
There is a sensor on the tray below the pickup roller. Not sure if it is a set sensor but it does work in sensor check. After looking at the manual it appears that the tray should lift but this doesn't happen. Doesn't seem the manual explains what exactly tells the lift motor to start.