PDA

View Full Version : Konica Minolta C20 - stuck in warm up phase


Custom Search


Shadow
11-06-2013, 11:49 PM
hi all,

I have a client with a C20 that has seen minimal use over the years, and I have replaced the fuser 2 weeks ago.
the fuser was replaced due to a deformed lower press roller, really deformed due to sitting for a year or so unused.
the machine is constantly saying it is warming up, it does come to ready some times.
I have checked the KM site to see if there was a firmware update for this issue, but was unable to locate anything.
my final thought would be that the new fuser unit is defective, any other suggestions would be greatly apprecited.

thank you

blaze2000
11-08-2013, 01:12 AM
If you replaced the fuser as an assembly, yeah, sounds like the fuser unit is bad.

JustManuals
11-08-2013, 03:16 AM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


http://www.justmanuals.com

paul@justmanuals.com

Custom Search