View Full Version : C351 test toner motor?
mrfuser
11-15-2013, 10:54 PM
Is there any way in service mode to test that the toner motor is turning on a bizhub c351?
been a while and I can't see I/o in servce mode.
kelly
JustManuals
11-15-2013, 10:57 PM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
http://www.justmanuals.com
Paul@justmanuals.com
Blizzoo
11-16-2013, 10:29 AM
1. Call the Service Mode to the screen.
2. Touch these keys in this order: [Imaging Process Adjustment] → [TCR Toner Supply].
3. Select the color, for which supply of toner is to be replenished.
4. Pressing the Start key will let the machine detect the current toner density and; if the
density is lower than a reference value, a toner replenishing sequence and then a
developer agitation sequence are run.
5. These sequences are repeated up to a maximum of four times until the toner density
reaches the reference value. If the toner density is found to be higher than the reference
value, only a developer agitation sequence is carried out.
I don't have the c351 manual,but i think this section above is on all colors
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.