View Full Version : Miscellaneous Is this a transfer belt problem? (konica minolts bizhub pro c5500)
kowloonkid
12-18-2013, 05:17 PM
Hi Guys,i'm seeing a streak of black toner going down the side of my page, i was wondering if one of you great gurus can shed some light on this, much appreciated.
Mick01
12-18-2013, 11:29 PM
Hi,
Could be either transfer or drum cleaning failure. If the toner on the page is black only it will be drum, if it is a mix of colours it wil be transfer belt cleaning failure.
Hope this helps
JustManuals
12-19-2013, 02:14 AM
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
http://www.justmanuals.com
Paul@justmanuals.com
dljorg
01-27-2014, 05:41 PM
If that black area is from lead to trail edge of the paper it sure looks like a failed developer unit to me.
As bad as that one is you should be able to see something if you remove the transfer belt and drum to look at the magnetic developer brush in the dev unit.
igorp86
01-28-2014, 01:33 PM
Swap drum bk and yellow and then try. If there is no this tone then is drum cleaning unit of bk, from this picture it seems so. Hope it helps
SEnder
06-24-2014, 11:16 AM
Check corona wire on K
Hansoon
06-24-2014, 01:14 PM
12-18-2013
Hans
jzheld
07-02-2014, 08:15 PM
Hi Guys,i'm seeing a streak of black toner going down the side of my page, i was wondering if one of you great gurus can shed some light on this, much appreciated.
First of all, what is the paper set up regular or R, if R i would say it's drum, but could be all that mentioned above. More info needed to determine exact problem.
KM1Amsterdam
07-02-2014, 10:05 PM
swap the charge units and take a close look at the black DV-unit.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.