C652 missing print

[KEN]

Hi
i have problem with C652 ,the transfer belt and roller have been replaced but problem persists
any help appriciated
see attached image of C Y M K halftone images A3

[EarthKmTech]

you need to do the stop test to determine where the problem is actually occurring.

[blackcat4866]

Ditto that. Run those images ledger/A3, then pop the door open when it's just reaching the fuser. Logically it's got to be primary or secondary transfer. Does the developed image on the primary belt look good? Does the unfused image on the paper look good? =^..^=

[JustManuals]

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


http://www.justmanuals.com


Paul@justmanuals.com

[RRodgers]

Is your waste box full of gritty stuff?!?! Looks like you've lost dev on ALL your IU's. How are the HV connections on the machine? I'd check them and be sure that they are clean. I'd be willing to bed you might have a HV unit that is going out and pulled dev.

[KEN]

Fixed should have spotted it sooner
rear arm of transfer roller holder broken underneath

[copier tech]

I had one of those break last week, I repaired the broken part with a cable tie. What item did you order to fix this?

[KEN]

Hi
The rear arm is A0P0710501 and the one it goes through is 4036471201

[copier tech]

Hi
The rear arm is A0P0710501 and the one it goes through is 4036471201

Cool thanks, how easy is this part to replace BTW?

[KEN]

Cool thanks, how easy is this part to replace BTW?
Easy to fit 1 circlip on arm and 1 spring on part it goes into

[copier tech]

Thanks, i'll order this part & replace next visit

[EarthKmTech]

Thanks, i'll order this part & replace next visit

these seem to snap all the time, I carry them in my car - still happens with the 654e / 754e too.