Konica Minolta C6000. Creasing lead edge of side 1.

[Grantow]

Afternoon All.

Has anyone seen this before?
Konica Minolta 6000 creasing lead edge about 10cm in, side one, before fusing. Coated stock 150gsm Satin. Sheet is feed from LCT does this from both tray 4 & 5 and seems to print fine from trays 1-3.

Any help/points would be much appreciated.

photo.JPG

Regards,
Grant

[Mick01]

Re: Konica Minolta C6000. Creasing lead edge of side 1.

Hi,
If it is only from tray 4 and 5 check your feed loop settings. Your registration loops may be set too high for those trays.