View Full Version : Jamming Bizhub C6000 banner printing problem with finisher FS-612
geralditec
04-01-2014, 02:56 PM
Hi, I have a bizhub C6000, with finisher FS-612. I can print 300x900mm banner page but jams/ stops in finisher, and printing completed, so not stuck in fuser, just in finisher, then. I have to remove manually from finisher. Page fully printed but I can't get it to exit properly without doing manually by hand. I did change the dipswitch 10.0 so i can select sizes, just the exiting from finisher that is problem. Do you maybe have any suggestions?
silviux
04-01-2014, 08:15 PM
Hi, I have a bizhub C6000, with finisher FS-612. I can print 300x900mm banner page but jams/ stops in finisher, and printing completed, so not stuck in fuser, just in finisher, then. I have to remove manually from finisher. Page fully printed but I can't get it to exit properly without doing manually by hand. I did change the dipswitch 10.0 so i can select sizes, just the exiting from finisher that is problem. Do you maybe have any suggestions?
I do not speak English but ...
Translate document from the italian
24607
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.