climbguy
04-03-2008, 03:01 PM
Title says it all, the BizHub is printing on an angle. Any ideas on how to recalibrate it?
pepper38_cnd
04-04-2008, 12:25 AM
Are you referring to skew, is it from all trays, prints and copies? All colors? The title doesn't say it all. But I would make sure the access door right below the bypass tray is closed properly, if this door latches on one side only you will have about a quarter inch skew from the lower trays.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.