View Full Version : Konica Minolta Bizhub C353
mearmi
07-18-2014, 07:24 AM
Got one Bizhub C353 with light Copies. When need to do gradation it doesn't work as it shows Stablizer NG.
Print is acceptable, only copies are very light. (Completely Serviced-Mirrors etc.)
Any advice.
Thanks a lot.
mearmi
EarthKmTech
07-18-2014, 08:01 AM
if its saying stabilizer NG there will be a reason for it.
goto the warnings counter and see what P codes its complaining about and this will help you.
There will also likley be an oil can at the bottom of the normal screen with a P code in it too.
mearmi
07-21-2014, 11:23 PM
if its saying stabilizer NG there will be a reason for it.
goto the warnings counter and see what P codes its complaining about and this will help you.
There will also likley be an oil can at the bottom of the normal screen with a P code in it too.
Thanks a lot for your reply.
P5 is there. Please advise what is that for?
kind Regards
Thanks a lot for your reply.
P5 is there. Please advise what is that for?
kind Regards
You need clean the IDC sensor ( front ) .better clean both side
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.