PDA

View Full Version : Bizhub C360 (DF-617) pulls multiple sheets


Custom Search


altech
07-23-2014, 06:13 PM
The doc feeder pulls multiple sheets through when it's gets down to the last 5 or so pages. I have replaced all of the rollers, the sep. pad assembly, and even changed out the whole doc feeder. The customer is running plain 8 1/2" X 11" paper through. Any solutions?

CompyTech
07-23-2014, 08:16 PM
Did you change out with a known good ADF? If so, there are adjustments to be made in service mode, also mechanical like height adjustment etc.

Kmdurrin
07-23-2014, 10:17 PM
Increase the resolution by one step to slow down the paper feed. The doc feeds on this series have multi-feed problems when the resolution is set to 200x200. This has worked for most of our C360s in the field.

fishleg
07-24-2014, 12:44 AM
Can you change resolution for photocopying? Didn't think you could.

Sent from my Nexus 5 using Tapatalk

altech
07-24-2014, 02:46 PM
Can you change resolution for photocopying? Didn't think you could.

Sent from my Nexus 5 using Tapatalk

No, you can't only for scanning/faxing documents.

EarthKmTech
07-24-2014, 09:35 PM
put the sep roller pressure spring into the lowest setting - default is middle.

I am assuming you are running the correct, red feed and sep roller, not the older blue and gray as used in the c353 & c352 series, they are NOT interchangeable.

Phrag
08-01-2014, 09:00 AM
You could either a) Change the shaft and torque clutch on the Sep Assembly or b)use a fine sandpaper on the shaft where the torque clutch rotates/sits.

If this is slipping, thus supplying less of a friction force, multiple sheet feeds are more likely.

OR you could also add a little padding to the little plastic tabs on the pickup assembly so they sit up just a fraction higher.

All these have worked for me.

copier addict
08-01-2014, 02:42 PM
You have to remove sep roller and trim the mylar on the pre-sep pad. And also set the sep tension to the lowest level as EarthKmTech mentioned.
Hope this helps.

Custom Search