.original detection

[luis8832]

I have a C364e with a DF-701. When you lift up the cover and close it says original size detection but there is no original. I have tried it on other copiers and it just goes ready to copy. Any input is greatly appreciated.:cool:

[Mr Spock]

Find the setup instructions for the doc feeder and re-do them. You may also need to adjust the heigth of the front edge a little higher than stated as well.

[kingarthur]

take the glass out & clean it both sides, have had a couple do this, the last one all i did was wipe my hand briefly across the glass......some i've had to clean a few times

[EarthKmTech]

also make absolutely certain the white backing sheet on the adf is absolutely spotless in the detection area.

a single speck of filth will cause this in the right place.

[habik]

As EarthKMTech said, I had this couple of times!


Sent from my iDon't believe in marketing device using Tapatalk

[copier addict]

Make sure the magnet on the DF lines up with the reed switch under the front cover of the scanned bed.

[copierguru]

As stated clean the under side of the glass and clean the size sensors. Common problem with these machines