PDA

View Full Version : Miscellaneous .original detection


Custom Search


luis8832
07-24-2014, 10:16 PM
I have a C364e with a DF-701. When you lift up the cover and close it says original size detection but there is no original. I have tried it on other copiers and it just goes ready to copy. Any input is greatly appreciated.:cool:

Mr Spock
07-25-2014, 01:58 AM
Find the setup instructions for the doc feeder and re-do them. You may also need to adjust the heigth of the front edge a little higher than stated as well.

kingarthur
07-25-2014, 09:43 AM
take the glass out & clean it both sides, have had a couple do this, the last one all i did was wipe my hand briefly across the glass......some i've had to clean a few times

EarthKmTech
07-25-2014, 12:58 PM
also make absolutely certain the white backing sheet on the adf is absolutely spotless in the detection area.

a single speck of filth will cause this in the right place.

habik
07-25-2014, 06:11 PM
As EarthKMTech said, I had this couple of times!


Sent from my iDon't believe in marketing device using Tapatalk

copier addict
07-26-2014, 03:20 AM
Make sure the magnet on the DF lines up with the reed switch under the front cover of the scanned bed.

copierguru
07-26-2014, 05:12 AM
As stated clean the under side of the glass and clean the size sensors. Common problem with these machines

Custom Search