View Full Version : Miscellaneous .original detection
luis8832
07-24-2014, 09:16 PM
I have a C364e with a DF-701. When you lift up the cover and close it says original size detection but there is no original. I have tried it on other copiers and it just goes ready to copy. Any input is greatly appreciated.:cool:
Mr Spock
07-25-2014, 12:58 AM
Find the setup instructions for the doc feeder and re-do them. You may also need to adjust the heigth of the front edge a little higher than stated as well.
kingarthur
07-25-2014, 08:43 AM
take the glass out & clean it both sides, have had a couple do this, the last one all i did was wipe my hand briefly across the glass......some i've had to clean a few times
EarthKmTech
07-25-2014, 11:58 AM
also make absolutely certain the white backing sheet on the adf is absolutely spotless in the detection area.
a single speck of filth will cause this in the right place.
habik
07-25-2014, 05:11 PM
As EarthKMTech said, I had this couple of times!
Sent from my iDon't believe in marketing device using Tapatalk
copier addict
07-26-2014, 02:20 AM
Make sure the magnet on the DF lines up with the reed switch under the front cover of the scanned bed.
copierguru
07-26-2014, 04:12 AM
As stated clean the under side of the glass and clean the size sensors. Common problem with these machines
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.