PDA

View Full Version : Black lines on IKON 550/KM5500


Custom Search


Georgerc
08-05-2014, 08:41 PM
Hello Everyone,
I am getting two black lines of .5pt thickness along the feed side on my IKON 550. They are not at the centre, somewhere by the side, a few centimeters close to each other.
This is a very low production machine (Well, New startup with not much business! Bought a used one. )
It is used for walk in work. Hasn't reached the level for PM.
It was working fine with its usual hiccups.
I don't know where to start. I found a couple of posts here regarding lines. But they seem to be different from mine.
Any suggestions from the pros will be very much appreciated.

Thanks
George

Tek_services
08-05-2014, 08:49 PM
check inside developer unit for toner stone in the blade. it can make scrashes and lines on the drum cilinder

Custom Search