View Full Version : Bizhub C350 Password On Service Mode
befree
04-18-2008, 12:57 PM
Hi,
thanks for reading this.
Some Idiot put a password on rep tech service so, I cannot upgrade the firmware and maintenance operations as well.
Please, is there a way to make a reset or other to solve this problem?
Konica tells me to change the main unit but, it's very expensive.
Thanks and I hope somebody help me.
Robin
befree
04-19-2008, 06:08 AM
Hi,
thanks for reading this.
Some Idiot put a password on rep tech service so, I cannot upgrade the firmware and maintenance operations as well.
Please, is there a way to make a reset or other to solve this problem?
Konica tells me to change the main unit but, it's very expensive.
Thanks and I hope somebody help me.
Robin
123
redhotrob
04-19-2008, 12:42 PM
Have you tried the 9272....?
befree
04-19-2008, 02:07 PM
Have you tried the 9272....?
Hi,
what it is?
Thanks
maxtrax
04-25-2008, 04:06 PM
You need to perform a nv-ram clear. there is software you can put on a SD card and startup the engine holding down the utillity button.
befree
06-18-2008, 04:54 PM
Hi,
thanks for answering me.
Please, I'm really in trouble. Could you please tell me where to find this software ?
Thanks
Robin
You need to perform a nv-ram clear. there is software you can put on a SD card and startup the engine holding down the utillity button.
mtech
06-19-2008, 12:50 AM
Unfortunatly, Minolta is right. If you change the password by going into security mode and you forget it or do not know it you must replace the main PWB.
ifback
11-28-2011, 07:11 AM
Hi,
thanks for reading this.
Some Idiot put a password on rep tech service so, I cannot upgrade the firmware and maintenance operations as well.
Please, is there a way to make a reset or other to solve this problem?
Konica tells me to change the main unit but, it's very expensive.
Thanks and I hope somebody help me.
Robin
now i had this trouble, everybody help me.
thank a lot
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.